![]() To expand on what was said then so much what you do will depend upon the topology and where the Point to Point Link actually terminates. ![]() Last resort would be running dynamic routing on both Check Points and the routers and use a route based VPN between the Check Points. or a IPSEC tunnel directly between both routers by using a NAT IP for both routers (requires SEC license on the routers).either a GRE tunnel on the router which is routed over a IPSEC tunnel between the Check Points.In our experience this type of setup is best solved by adding: VPN interfaces are configured in GAIA and depending on the number of sites you need an exponential growing number of interfaces, if you want a full mesh.VPN interfaces are supporting dynamic routing, they are not supported in VSX. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |